Nht ST4 User Manual download pdf (Page 3)

Taking these steps -- all shown in Figure 1 -- will give you

the smoothest response, and put you right in the center

of the stereo image at its most well-defined point.

For five-channel music and home theater systems, use

the same basic setup -- all shown in Figure 2 -- and when

possible, set up the system so that:

• The center speaker is right above or below the TV.

• The rear speakers are in an equilateral triangle with the

listening position, the speakers at least 5 feet apart.

• The rear speakers are at the same height or slightly

higher than the fronts

In many situations, it won't be possible to place the rear

speakers in their ideal positions. If this is the case in

your room, try to place the rear speakers equidistant

from the center of the main seating area. If you must

place the rear speakers close to the main seating area,

position them so that they are above the ear height of the

tallest listener, and toe them in so that imaginary lines

coming from the center of each speaker cross in front of

the main seating area. You can add time delay to the

rear channels with your surround sound processor to

make the rear speakers seem farther from the seating

area than your room setup will allow.

SpikeKit Installation

Each ST4 loudspeaker is shipped with its own SpikeKit,

which both improves their stability and firmly couples the

speakers to the floor for improved bass performance.

To begin, unpack the SpikeKit and identify the parts: (2)

stabilizer bars, (4) metal spikes, (4) Phillips head

machine screws, (4) lock nuts and (4) rubber feet (fig. 3).

Start by carefully turning the speaker upside down (or on

its back) and installing the stabilizer bars. Attaching

them with the Phillips head machine screws, starting with

finger-tightening (to avoid cross threading) and finishing

with a #2 Phillips screwdriver.

Next, turn the speakers upright and position them. When

you've found the optimum location for each (the

speakers can be awkward to move after the spikes are

installed), slip the lock nuts onto the spikes, carefully tilt

the speakers, and screw in the spikes. Caution: The

spikes are very sharp. To avoid injury, use extreme care

when handling and installing them.

Adjust the spikes as needed to ensure that the ST4 is

level and does not rock in any direction, then tighten the

lock nuts against the bottom of the stabilizer bars to lock

the spikes in place.

lif

att

ici

Fig. 1

Fig. 2

Stabilizer

Bar

Lock

Nut

Spike

Cover

(8) (8) (8)

(4)

(8)

Metal

Spike

Machine

Screw

Fig. 3

1 2 3 4 5 6 7

Comments to this Manuals

No comments

Nht ST4 User Manual Page 3

Comments to this Manuals

Related products and manuals for Microphones Nht ST4